TechWhirl (TECHWR-L) is a resource for technical writing and technical communications professionals of all experience levels and in all industries to share their experiences and acquire information.
For two decades, technical communicators have turned to TechWhirl to ask and answer questions about the always-changing world of technical communications, such as tools, skills, career paths, methodologies, and emerging industries. The TechWhirl Archives and magazine, created for, by and about technical writers, offer a wealth of knowledge to everyone with an interest in any aspect of technical communications.
In light of the junk inundation (I'm down to +/-10 per day from >1K) I am
only now reviewing earlier digests from this week. (Hey, it's Friday.)
Another recommendation for a post-project review is to do a modified FMEA
(Failure Mode/Effect Analysis). Since an FMEA is usually done before/during
a project, doing it post-facto is not common, but has produced some
interesting results when I've participated in them.
There are basically four columns to this exercise; the first one (Failures)
includes the failures (either those that occurred or could have occurred;
you may consider adding the category of "what we did right" as well); the
second (Mode) is an explanation of WHY it (could have) happened; the third
(Effects) is a statement of the results of the failure (on the positive
angle, this would be a statement regarding what was avoided); and the last
column may be "Actions/Lessons," and offer the team a chance to either
generate a "Let's do this differently next time" statement, or a "This was a
positive decision."
In any case, I'd also recommend that you provide snacks (at least) and most
important, try to get a direct beneficiary of the project (customer?
manager? someone who received a benefit from the success of the project) to
either show up and talk for a few minutes (or a Q&A) or send a short message
to the team regarding his/her appreciation (hopefully) of the team's
efforts.
Hope this helps -
Joe Hauglie
Technical Editor, Texas Instruments - Tucson
jhauglie -at- ti -dot- com
NEED TO PUBLISH YOUR FRAMEMAKER CONTENT ONLINE?
?Mustang? (code name) is a NEW online publishing tool for FrameMaker that
lets you easily single-source content to Web, intranets, and online Help.
The interface is designed for FrameMaker users, so there is little or no
learning curve and no macro language required! See a live demo that
will take your breath away: http://www.ehelp.com/techwr-l3
---
You are currently subscribed to techwr-l as:
archive -at- raycomm -dot- com
To unsubscribe send a blank email to leave-techwr-l-obscured -at- lists -dot- raycomm -dot- com
Send administrative questions to ejray -at- raycomm -dot- com -dot- Visit http://www.raycomm.com/techwhirl/ for more resources and info.
